How to Change Can-Am Belt Without Tool

Can-Am drive belts have high-tensile strength carbon cords for extra durability and flexibility. Yet, from time to time, you have to replace the belt. Fun fact, you can change the belt without a tool. But, do you know how to change Can-Am belt without tool?

We will guide you through the replacement process, discuss how to maintain your Can-Am's performance and help you understand when it is time for a belt change. Let’s get started!

How to Change Can-Am Belt Without Tool

Changing the drive belt on a Can-Am vehicle without using a specialized tool might seem challenging, but it is possible if you approach it correctly. While specialized tools make the belt change easier, using just your hands may be similarly effective.

First, turn off your Can-Am and park it on a level surface. Next, pull the old belt out by turning the secondary clutch. Lastly, check and install the replacement belt.

Bear in mind that we have Can-Am equipment, and you can request a new drive belt from Wickham Tractor. For a detailed explanation, follow these steps on how to replace Can Am drive belt:

Preparation

Make sure the vehicle is on a stable surface and turned off. Disconnect the battery to prevent accidental starts.

Then, remove the cover of the clutch housing. This means removing several screws or bolts. We recommend you keep these screws safe, as you will need them to reassemble the cover later.

Removing the old belt

This step requires some manual effort. Rotate the secondary (driven) clutch by hand to relieve the belt's tension. This might take a bit of muscle, but it is crucial for removing the belt.

As you rotate the clutch, gently pull the belt off the secondary clutch. Continue rotating until the belt is free.

Installing the new belt

Before installing the new belt, check for directional arrows. These indicate the correct orientation for optimal performance. Next, slide the new belt onto the primary (drive) clutch first.

Now, carefully begin rotating the secondary clutch while guiding the belt onto it. Once the belt is partially on, rotate the secondary clutch by hand, allowing it to fully seat itself. Make sure the belt is properly aligned and tensioned.

Reassembly and testing

After the belt is in place, reattach the clutch cover securely. Reconnect the battery, start the vehicle, and perform a short test drive. As experts, we recommend listening for any unusual sounds and ensuring the belt is functioning correctly.

When to Replace Can Am Drive Belt

The drive belt is a crucial engine part in your vehicle, responsible for transferring power from the engine to the wheels. Over time, the belt can wear down due to heat, stress, and the demands of off-road driving. In the following, we provide signs that could indicate it is time for replacement:

• Visible wear: Check the belt to see whether it is cracked, glazing, or fraying. If there are signs of wear, this suggests that the belt is nearing the end of its life.

• Performance drop: A sudden drop in performance or strange noises from the belt area can show you the belt is worn out and needs replacing.

• Slipping: You may notice a loss of power or the engine revving higher than usual; the belt might be slipping, and it is time to change it.

Conclusion

You can now regularly maintain the belt lifespan and easily replace it when necessary. You are well-prepared with our steps on how to change Can-Am belt without tool.

As mentioned, place your vehicle on a stable surface and turn it off. Then, remove the old belt by rotating the secondary clutch and pulling it. Install the new belt and test it.

In addition, remember to follow the signs that indicate your belt needs a change. Our professionals are always available if you need any assistance!